NEWS

When buying and using quartz transition joints, people usually think that they are very smooth. This has also led some people to understand that transition joints can only be reserved for purchase and use. In fact, in addition to these, it is also part of the need to maintain. Inspections should be carried out before and after installation to avoid affecting the use or normal use of the transition joint. In the actual inspection process, there are still many inspections.

Quartz transition joint The oil pump is composed of a pump body, a rectangular oil tank, a pressure handle and an ultra-high pressure steel wire braided hose. The power components of the system are used to convert the mechanical energy of the prime mover into the pressure energy of the liquid. The oil pump that powers the entire system.

The first and most intuitive inspection is to check its appearance, check it for scratches, some defects, and no bending. Don't think these are unimportant. In fact, these are potential defects that affect its use. After the hydraulic transition joint is used for a period of time, check whether there is dirt in the joint frequently. If there is dirt between the connected pipes, if there is a blockage, if a blockage is found, it must be dealt with in time. Clean, so as not to affect the use of the transition joint and affect its service life. After the final check, be sure to check whether there is any tightening at the end. The above are the complete and correct inspection steps, and one person can complete the inspection.

The bell-shaped pipe joints in the quartz transition joints are mostly caused by excessive flaring, and there is no need to disassemble the quality multiple times, resulting in bell-shaped deformation or cracks leakage. At this time, the front end can be cut off and unfolded again. If the male cone and female cone are used for sealing, the leakage is mainly due to the damage of the two cone surfaces, which can be ground. "" The ring is not compressed, and the elastic deformation is not enough to cause leakage, and the ring is too deep to cause leakage.

In this regard, the quartz transition joint needs to re-select the ring with the same outer diameter and thicker section. It can cut or grind the grooved sealing surface , To reduce the depth of the groove. The ring has sufficient elastic deformation. For the leakage of pipe joints with oil-resistant rubber sheets, wool felt, mild steel cardboard, combined gaskets or sealants, first check whether the seals are damaged, deformed, aging and rough, no matter what material is used. Then take appropriate measures.